[VIDEO] How to Set Up the DHT11 Humidity and Temperature Sensor on an Arduino Posted by Scott Campbell | Videos | 2
Suzie Feodoroff on January 22, 2016 at 8:35 am Ha! I needed this yesterday! Took me hours googling help. Instructions I had were for 4 pin DHT not 3 pin.
![[VIDEO] How to Make an Arduino Ohm Meter](https://www.circuitbasics.com/wp-content/uploads/2015/01/How-to-Make-an-Arduino-Ohm-Meter-440x264.png)
![[VIDEO] How to Design and Build a TDA2050 Stereo Amplifier](https://www.circuitbasics.com/wp-content/uploads/2017/01/How-to-Design-and-Build-an-Amplifier-With-the-TDA2050-440x264.png)
![[VIDEO] How to Set Up the DHT11 Humidity Sensor on the Raspberry Pi](https://www.circuitbasics.com/wp-content/uploads/2016/05/How-to-Set-Up-the-DHT11-Humidity-Sensor-on-the-Raspberry-Pi-440x264.png)
![[VIDEO] The 555 Timer in Monostable Mode](https://www.circuitbasics.com/wp-content/uploads/2015/01/The-555-Timer-in-Monostable-Mode-440x264.png)
Ha! I needed this yesterday! Took me hours googling help. Instructions I had were for 4 pin DHT not 3 pin.
handy as just bought one of these sensors! #arduino